Moderator: Steering Group
Ian Linden wrote:The rear window can get in the way. I found it helpful to pull it forward of the hoop, so that the bottom comes clear of the coaming (lubricate it well when the time comes to get it back inside the coaming, and it will go in).
Christine Maguire wrote:Remove 4 screws ( of the six) beneath the comb ( you cannot get at the front two but no matter).
Christine Maguire wrote:GENTLY waggle comb till it comes free and lift max of 3inches to reveal the two screws holding rear reflector/ empty light fitting.....
Christine Maguire wrote:.....remove these with v small stubby posidrive type driver
Ian Linden wrote:The engineer who specified the glue which fastens the lamp unit lens to the body did not intend you to open it! The lens material is very brittle, so great care is needed. Loctite release fluid has been suggested for dissolving the glue. I had success with a paint brush cleaning agent, which did not attack the plastic, but, very slowly, dissolved the glue. Try on an inconspicuous corner, and expect to take a long time. Very gentle pressure only.
Christine Maguire wrote:Open with craft knife( scoring along glue line) CAREFULLY.
Users browsing this forum: No registered users and 9 guests